Blitzsafe install accord




















Tire Rack Upgrade Garage. Search for a Dealer:. American Honda reports December and overall sales results More American Honda reports November sales results More Hondata dyno results: Si is about 20hp stronger than Si More Join Discussion The part was told to be in within 3 days of my order.

Well, not so much. I basically called the shop everyday from mid March up till this past Friday, the 10th asking if the part has came in yet. It finally did on Friday. Part came, just as expected, right everything, I was happy. Use you index finger to pull up on the plastic from the Ebrake cup out and your other hand inside against the cup holder. Pull firmly until it pops.

Use a interior pry tool or a flat head screwdriver with a cloth to gently pry the plastic further. There are 4 clips around the gear shifter and 2 more in front of it. I gently and slowly wedged and twisted the screw driver in those 4 areas to pop the plastic clips out. Once they were out the 2 in fornt of the shifter were left. If you don't hear your music playing, make sure that the volume knob is turned above the "0" muted setting.

Route the 3. You may choose to route the AUX input wire to either the driver or passenger side of the vehicle. Firmly push the Blitz Safe unit to the rear wall of the area just below the radio. You may also choose to use cable ties to secure the wires to the other harnesses to prevent any rattles or noises from the loose cables. Carefully slide the plastic 12V power outlet tray back under the radio.

Re-insert the rear wall plastic trim cover back into the storage compartment. Firmly push on the trim cover to secure the retaining clips. Spin in the two black metal screws near the front edge of the ashtray mounting tray. They are situated at a slight angle.

Then replace the two brass colored screws located slightly further back from the front of the tray. Spin them in a few turns by hand to prevent from having them fall and become lost. Replace the black metal screw at the bottom right corner of the storage drawer by turning it clockwise with the Phillips head screwdriver.

Replace the brass screw into the middle of the rear wall by turning it in the clockwise direction with the long Phillips head screwdriver. Replace the rubber mat to the bottom of the storage compartment. If you have trouble re-inserting the ashtray, be sure to angle the front edge down a bit while sliding it in.

Test the AUX input again to make sure that everything is working properly. If you hear a whining, hissing or whistling noise from the speakers while driving and listening to music through the BlitzSafe unit, I recommend attaching a ground loop noise isolator to the AUX input wire. If you found this guide to be helpful, please consider making a small donation by clicking on the PayPal.

Thank you! Note: I am not a registered charity. Donations are not tax deductible. Pictures Articles My Blog Home. Pictures Articles My Blog. Shifter Back To 1 - 2. Pull Out "Not An Ashtray". Pull Slightly Down. Storage Tray Removed. Turn the ignition switch to the "OFF" position. Bottom Rubber Mat. Remove Rubber Cover. Brass Screw - Rear Wall. Remove the rubber mat from the bottom of the storage compartment below the "not an ashtray" and 12V power outlet.

Loosen Counterclockwise. Brass Metal Screw Removed. Rear Wall Screw Removed. Use a long Phillips head screwdriver to loosen the brass metal screw in the counterclockwise direction a few turns. Loosen Top Screws. There are four screws on the top wall or "ceiling" of the mounting plate for the "not an ashtray" drawer.

Lower Right Black Screw. Then loosen the black metal screw on the rear wall at the lower right passenger side corner of the plastic panel. Spin Out By Hand. Lower Right Screw Removed. Spin out the black metal lower right rear screw the rest of the way by hand to prevent from losing it. Front Edge Screws. Angled Front Edge Screws. Then remove the two black metal screws that are mounted at an angle near the front edge of the "not an ashtray" tray.

Remove Left Front Screw. Black Metal Screw Removed. Set Screws Aside. Uses playlists and digital interfaces. Does this Blitz model work with the volume control and have CD text option allowing you to play the playists on your Ipod? The connection is through bottom connector on the iPod not earphone jack which allows charging while playing and will also charge iPod for 30 minutes after turning off ignition.

Volume is adjusted either through radio knob or steering wheel control. No CD text Other than volume, all ipod control ie playlists is thru clickwheel. Well I am not going to dump too much money into my car. I will get the Blitzsafe option.

I am surprised now they offer the CD text option for the Ipod. Alas, advances in technology. Thank you for your feedback. Have a great memorial day weekend!



0コメント

  • 1000 / 1000